How to use 2 ton manual cable puller with double gear

- Feb 07, 2019-

The 2 ton manual cable puller with double gear is an auxiliary tool for installing the cable. It will be clamped with one end to clamp the cable at the other end. The other end will wrap the 8th wire around the wheel to the pulley. Pay attention to the iron. The wire end is inserted into the hole in the middle of the pulley to be fixed, and the other end of the wire is fixed to the anchor of the wire.
 
At this point, put a 2 ton dual gear manual tightener wrench into the square head of the pulley shaft and tighten the tensioner wrench to tighten the cable. Note that the other end of the tensioner pulley has a anti-loose device. It must be stuck with the gear, fix the cable, loosen the tensioner release device, open the jaw at the other end of the tensioner, and the tightener works.
 
To put it simply, first insert a wire of suitable thickness and length into the circular hole in the middle of the take-up wheel of the 2 ton manual cable puller with double gear, and wind the wire twice in the wire take-up reel to make the wire another One end is tied to the fixed point along the take-up direction, and then the wire is straightened, and the wire of the tensioner is fixed on the wire, and the handle can be moved to tighten the wire.

http://www.yc-lift.com/