Slip line phenomenon of cable puller and tightening cable

- Jul 17, 2018-

To a certain extent, the cable puller will effectively select the tightener according to the thickness of the wire. When using it, the wire rope should be effectively smoothed, and the twisting phenomenon should not occur. The ratchet and pawl should be intact. Active, there can be no tripping. It should be added to the oil lubrication often.

When the cable puller is in use, if it is found that there is a slip line, it needs to be stopped immediately, and to some extent, take corresponding measures to effectively clamp the wire and continue to use it.

To some extent, the ratchet cable puller is also called a ratchet lever hoist. To a certain extent, it is a tool for tightening and tightening steel strands and small-section conductors in the construction of transmission lines. Usually use a cable clamp to fix the wire, and then tighten the wire to the appropriate sag by the tensioner.

To a certain extent, the double hook cable puller is a tightening cable for the construction of the transmission line engineering. During operation, the position of the equipment or equipment can be effectively adjusted, and the insulator and other construction processes can be replaced to some extent. The tool to use when tightening. The double hook tightener has two kinds of steel and aluminum alloy. The former is heavier, but the bearing capacity is large, and the maximum can carry the tension of 100kN. The latter is light in weight and convenient to carry, but the maximum load is generally not more than 50kN.

http://www.yc-lift.com/